Static IP address Aironet 1200 - Controller 4002

Unanswered Question
Jan 30th, 2008
User Badges:

Hi!


I have a 1200 series LWAPP. It has the default configuration which means it has configured the static IP address 10.0.0.1.

How can I change the address or how can the AP discover the controller address?


Ana




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Wed, 01/30/2008 - 07:01
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Ana,


WLC Discovery process. Have a look in this good doc;


Lightweight AP (LAP) Registration to a Wireless LAN Controller (WLC)


http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml#topic2


For the Static entry question;


If this AP was ever registered you can use this command from the LAP CLI to clear the LWAPP configuration on the LAP:


clear lwapp private-config



This allows you to use the AP LWAPP static configuration commands again.


Here is an example:


Enable (enter password)


AP1240#clear lwapp private-config


AP1240#lwapp ap hostname AP1240


AP1240#lwapp ap ip address 10.77.244.199 255.255.255.224


AP1240#lwapp ap ip default-gateway 10.77.244.220


AP1240#lwapp ap controller ip address 172.16.1.50


Note: You cannot use the clear lwapp private-config command when the LAP is registered with the controller.


http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml#t2



Hope this helps!

Rob


Actions

This Discussion