cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
870
Views
0
Helpful
1
Replies

Static IP address Aironet 1200 - Controller 4002

abartolomeu
Level 1
Level 1

Hi!

I have a 1200 series LWAPP. It has the default configuration which means it has configured the static IP address 10.0.0.1.

How can I change the address or how can the AP discover the controller address?

Ana

1 Reply 1

Rob Huffman
Hall of Fame
Hall of Fame

Hi Ana,

WLC Discovery process. Have a look in this good doc;

Lightweight AP (LAP) Registration to a Wireless LAN Controller (WLC)

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml#topic2

For the Static entry question;

If this AP was ever registered you can use this command from the LAP CLI to clear the LWAPP configuration on the LAP:

clear lwapp private-config

This allows you to use the AP LWAPP static configuration commands again.

Here is an example:

Enable (enter password)

AP1240#clear lwapp private-config

AP1240#lwapp ap hostname AP1240

AP1240#lwapp ap ip address 10.77.244.199 255.255.255.224

AP1240#lwapp ap ip default-gateway 10.77.244.220

AP1240#lwapp ap controller ip address 172.16.1.50

Note: You cannot use the clear lwapp private-config command when the LAP is registered with the controller.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml#t2

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: