NAT Problem with Remote Access?

Unanswered Question
Jan 30th, 2008

My office runs a small business server with a Cisco 1811 in front. I need to access ports 80 and 443 from the outside so I used a static NAT for the server IP. I also setup IPSec VPN on it. When I remote in, I can access anything on the network except for the server which is NAT'ed. If I remove the NAT, I can access the server through the VPN. Any idea why this is happening? What part of the config would you need to see to better assist in resolution?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dongdongliu Wed, 01/30/2008 - 19:47

Hi,

maybe "below" is needed

access-l 100 deny ip host (server_ip)(vpn_peer_ip) (netmask)

access_l 100 per ip (server_ip) any

ip nat inside source list 100 pool nat_pool

ip nat pool nat_pool (server_ip)

Actions

This Discussion