FXO rotary configuration

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
pcameron Thu, 01/31/2008 - 03:01

Use the preference command under the POTS dial peers to set up a order of outbound hunting. Preference 0 is the default, so it does not show in the config, so leave it off your first dial peer, then add preference 1-9 for the other dial peers.

Paolo Bevilacqua Thu, 01/31/2008 - 03:13

voice-port x/y/z

trunk-group pots

dial-peer voice 9 pots

destination-pattern 9T

trunkgroup pots

This allows you to configure a single DP to control all lines. You can also set other properties under "trunk group pots"

Hope this helps, please rate post if it does!


This Discussion