UC520 CUE IP setup

Unanswered Question
Jan 30th, 2008

Why is it that the default UC520 setup uses a /30 subnet for the CUE configuration? Can I do without that and simply assign an IP to CUE that is the same as my voice VLAN?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Paolo Bevilacqua Thu, 01/31/2008 - 02:43

The cue must be accessed via the service-engine interface. If you want to give it an address off router LAN, you can use an host route to it. This technique is described in the configuration manual.


This Discussion