ACS Problem

Unanswered Question
Jan 31st, 2008


I have 2 ACS SE, one primary and the other secondary. when I've configured them, all operation seems completed correctly, clients can authenticate successfully. but when I restart them,no authentication is performed, I cheked the Network Configuration page in the Primary ACS and I detect that the following is added to the AAA servers"self with an address". the address is unchangeable neither the Secret key.

any one have some idea?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
acharyr123 Thu, 01/31/2008 - 04:18

When u add the ACS in AAA Server option at Network Configuration u will get "Self" for ACS with the IP of the device...not

It seems both these devices are nt configured properly in active/standby mode.

Please try to add the same with the exact IP of the primary ACS..It should work!!!

Rate if it helps!!!

ismail884 Thu, 01/31/2008 - 06:55

I've used the Engine Recovery CD. and I reconfigured the ACS.this time I verified that all thing is working properly. I configured the IP address and I restart the ACS many times.

thank you



This Discussion