DSL controller problem

Unanswered Question
Jan 31st, 2008

Hi,

I've a problem with my DSL controller, I configured this one but the controller is flapping UP-DOWN-UP-DOWN, I tried several parameters but still NOK, have you an idea why? Thanks in advance.

HERE's my config.

controller DSL 0/0/0

mode atm

line-term cpe

line-mode auto

dsl-mode shdsl symmetric annex B

Do it can be due to the firmware on the controller?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Paolo Bevilacqua Thu, 01/31/2008 - 02:57

When reporting problems, at the minimum, always include router model and exact IOS used.

yavuz.ozdemir Thu, 01/31/2008 - 04:54

Sorry, here's more info. :

Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(17a), RELEASE SOFTWARE (fc)

Cisco 2811 (revision 53.50) with 251904K/10240K bytes of memory.

Processor board ID FCZ120273RJ

1 DSL controller

2 FastEthernet interfaces

4 ISDN Basic Rate interfaces

1 ATM interface

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

yavuz.ozdemir Thu, 01/31/2008 - 04:55

Router#sh controllers dsl 0/0/0

DSL 0/0/0 controller DOWN

SLOT 0: Globespan xDSL controller chipset

DSL mode: Not Trained

Frame mode: Utopia

Configured Line rate: 4608Kbps

Line Re-activated 53 times after system bootup

LOSW Defect alarm: ACTIVE

CRC per second alarm: ACTIVE

Line termination: CPE

FPGA Revision: 0xB2

Line 0 statistics

Current 15 min CRC: 0

Current 15 min LOSW Defect: 0

Current 15 min ES: 0

Current 15 min SES: 0

Current 15 min UAS: 180

Previous 15 min CRC: 0

Previous 15 min LOSW Defect: 0

Previous 15 min ES: 0

Previous 15 min SES: 0

Previous 15 min UAS: 871

Line 1 statistics

Current 15 min CRC: 0

Current 15 min LOSW Defect: 0

Current 15 min ES: 0

Current 15 min SES: 0

Current 15 min UAS: 203

Previous 15 min CRC: 0

Previous 15 min LOSW Defect: 0

Previous 15 min ES: 0

Previous 15 min SES: 0

Previous 15 min UAS: 737

Line-0 status

Chipset Version: 0

Firmware Version: R3.0.1

Modem Status: Handshake, Status 10

Last Fail Mode: No Failure status:0x0

DSL firmware download in progress, please wait

Line-1 status

Chipset Version: 0

Firmware Version: R3.0.1

Modem Status: Handshake, Status 10

Last Fail Mode: No Failure status:0x0

DSL firmware download in progress, please wait

Dying Gasp: Present

Actions

This Discussion