01-31-2008 05:07 AM - edited 03-03-2019 08:30 PM
how to configure G703 ethernet interface ,in background of this many different locations are connected with one G703 interface, Kindly advice.
01-31-2008 06:15 AM
Hi
can you revert on what type of circuit is being subscribed on the G.703 interface ?
regds
01-31-2008 06:21 AM
Ethernet is not G.703. E1 and T1 are G.703 interfaces, however cisco refers to unframed E1 as G.703.
This is called channelized configuration (propert ITU name is G.704) and is a service that you obtain from you carrier:
controller E1 x/y/z
channel-group 0 timeslots 1
channel-group 1 timeslots 2
interface serial x/y/z:0
ip address ...
hope this helps, please rate post if it does!
01-31-2008 09:45 PM
Hi p.bevilacqua
Thank you for your reply.i can little bit understand kindly inform me in little detail, how can distribute the bandwidth with each channel.if you don't mind kindly give me the sample configuration of that type of interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: