I have a CP-7921G phone that cannot connect to AP1242AG. It keeps saying "locating network services". (I think if the WEP key does not match, "authentication failure" will display.) But it is working well with BR1310G bridge. The configurations are identical in these 2 devices.
On the bridge:
---------------
dot11 ssid ABCD
authentication open
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption key 1 size 128bit xxx transmit-key
encryption mode wep mandatory
!
ssid ABCD
!
speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
channel 2412
station-role root access-point
antenna receive right
antenna transmit right
world-mode dot11d country NZ both
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
---------------------------
On the AP:
----------------
dot11 ssid ABCD
authentication open
!
dot11 network-map
power inline negotiation prestandard source
!
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption key 1 size 40bit xxx
transmit-key
encryption mode wep mandatory
!
ssid ABCD
!
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
world-mode dot11d country NZ both
bridge-group 1
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
-----------------------------
Can anybody see any configuration errors?
What do you advise me to do next?
Thanks.
