New ASA 5500 - no default config at startup

Unanswered Question
Jan 31st, 2008
User Badges:

Started the box up with console connected and received the message that no image could be found. So I went into Rommon and set up an interface to work with my TFTP server. Copied .bin over fine and started up. But when I go to save to memory I get this:

"%Error opening disk0:/.private/startup-config (No device available)"


and when I do a show flash, I get this:


"%Error show flash: (No device available)"


Does this mean my machine was shipped with no flash memory?? Where can I look to figure out what I'm doing wrong? I loaded on 7.2 btw. I also tried 8.0 but same thing.


Thanks in advance,


Dave



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ajagadee Thu, 01/31/2008 - 20:18
User Badges:
  • Cisco Employee,

It looks like the Flash has been corrupted. So, you most probably need to open a TAC case and RMA the chassis.


Regards,

Arul


** Please rate all helpful posts **



Actions

This Discussion