01-31-2008 09:51 PM - edited 03-03-2019 08:31 PM
controller E1 x/y/z
channel-group 0 timeslots 1
channel-group 1 timeslots 2
<repeat for all needed channels>
interface serial x/y/z:0
ip address ...
Kindly give me the complete sample configuration of about mention configuration commands.(G703/G704)
01-31-2008 10:47 PM
Your question doesn't really make any sense. The config listed above is for framed operation, which is different to G703.
For unframed G703, you use this CLI snytax -
controller e1 0/0/0
channel-group 0 unframed
interface serial 0/0/0:0
ip address ...
This then makes the entire E1 a single channel group.
http://www.cisco.com/en/US/docs/ios/12_1t/12_1t1/feature/guide/dtg703.html
02-01-2008 01:00 AM
Paul, Adnan is following up to an answer of mine. He needs info about channelized information.
Adnan, these are all the commands required. If the hardware is a vwic2, you also need "card type E1
02-01-2008 01:20 AM
a g703 e1 card vwic2 doesnt need the card type command as it is only an e1 card it is not an e1/t1,hth
02-01-2008 01:33 AM
On the other hand, the expensive vwic2 G.703 version is wasted for a channelized application, because it is really made for the unframed application that Paul mentioned before.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide