02-01-2008 05:11 AM - edited 03-05-2019 08:52 PM
GigabitEthernet0/3 is up, line protocol is down is error i ma getting what hsould i check and how to rectify it
Solved! Go to Solution.
02-01-2008 05:33 AM
Amit
Interface up line protocol down sometimes means that there is not anything plugged into the interface.
I believe that it can also result from a speed mismatch. So check the switch interface and verify speed and duplex settings. Then verify on the device connected to the port what its speed and duplex settings are. Make sure that speed and duplex settings are the same.
HTH
Rick
02-01-2008 05:33 AM
Amit
Interface up line protocol down sometimes means that there is not anything plugged into the interface.
I believe that it can also result from a speed mismatch. So check the switch interface and verify speed and duplex settings. Then verify on the device connected to the port what its speed and duplex settings are. Make sure that speed and duplex settings are the same.
HTH
Rick
02-01-2008 08:24 AM
Amit
I am glad that my answer was helpful. Thank you for using the rating system to indicate that your issue was resolved (and thanks for the rating). It makes the forum more useful when people can read about an issue and can know that they will read about the successful resolution of the issue.
The forum is an excellent place to learn more about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide