Translation rule for incoming calls

Answered Question
Feb 1st, 2008

Hi to all,

problaby my question is stupid, but I don't know to resolve.

I have a CME on 2811, for each incoming calls it strip the first left zero digit of number (DID).

Can I with translation rule put this zero? Or better can I prevent any digit stripping of incoming calls?

Augusto

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 8 years 11 months ago

Augusto, CME is not stripping anything, it's the normal way of TI to present numbers this way, as they use ISND type/plan.

The translation-rule below, will prefix 0 for fixed number, 00 for international, nothing for cellulars:

voice translation-profile addzero

translate calling 10

voice translation-rule 10

rule 1 // /0/ type national national

rule 2 // /00/ type international international

int bri x/y

trunk-group bri

trunk group bri

translation-profile incoming addzero

Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Paolo Bevilacqua Fri, 02/01/2008 - 07:38

Augusto, CME is not stripping anything, it's the normal way of TI to present numbers this way, as they use ISND type/plan.

The translation-rule below, will prefix 0 for fixed number, 00 for international, nothing for cellulars:

voice translation-profile addzero

translate calling 10

voice translation-rule 10

rule 1 // /0/ type national national

rule 2 // /00/ type international international

int bri x/y

trunk-group bri

trunk group bri

translation-profile incoming addzero

Hope this helps, please rate post if it does!

a.crippa Fri, 02/01/2008 - 07:49

Hi Paolo,

you understand exactly my problem (yes I know it's TI issue), thank now it's OK.

Augusto.

Actions

This Discussion