02-01-2008 07:33 AM - edited 03-15-2019 08:34 AM
Hi to all,
problaby my question is stupid, but I don't know to resolve.
I have a CME on 2811, for each incoming calls it strip the first left zero digit of number (DID).
Can I with translation rule put this zero? Or better can I prevent any digit stripping of incoming calls?
Augusto
Solved! Go to Solution.
02-01-2008 07:38 AM
Augusto, CME is not stripping anything, it's the normal way of TI to present numbers this way, as they use ISND type/plan.
The translation-rule below, will prefix 0 for fixed number, 00 for international, nothing for cellulars:
voice translation-profile addzero
translate calling 10
voice translation-rule 10
rule 1 // /0/ type national national
rule 2 // /00/ type international international
int bri x/y
trunk-group bri
trunk group bri
translation-profile incoming addzero
Hope this helps, please rate post if it does!
02-01-2008 07:35 AM
Augusto,
Can you post your config?
Brandon
02-01-2008 07:38 AM
Augusto, CME is not stripping anything, it's the normal way of TI to present numbers this way, as they use ISND type/plan.
The translation-rule below, will prefix 0 for fixed number, 00 for international, nothing for cellulars:
voice translation-profile addzero
translate calling 10
voice translation-rule 10
rule 1 // /0/ type national national
rule 2 // /00/ type international international
int bri x/y
trunk-group bri
trunk group bri
translation-profile incoming addzero
Hope this helps, please rate post if it does!
02-01-2008 07:49 AM
Hi Paolo,
you understand exactly my problem (yes I know it's TI issue), thank now it's OK.
Augusto.
02-01-2008 07:53 AM
You are welcome, thanks for the nice rating and buona fortuna!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: