EIGRP Issue Connecting Two ASA int to Two Router Int

Unanswered Question
Feb 2nd, 2008
User Badges:

On a router I get an EIGRP can't find upstream IP and vice versa on the ASA as I have two FA plugged into two Gig E (stepped down) on the ASA. There are two tunnels going out both interfaces but I get these errors simply pinging from the upstream routers.

Any ideas about the EIGRP error?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ajagadee Sat, 02/02/2008 - 05:51
User Badges:
  • Cisco Employee,

Can you post the exact messages that you are seeing from the Pix and router. Also, are you trying to configure EIGRP across the IPSEC Tunnel.



mlenco Sat, 02/02/2008 - 06:14
User Badges:

EIGRP% Cannot find adjacent neigh IP address.

I have eigrp network statements on the ASA and router but I haven't configured any routing commands on the tunnel.

mlenco Mon, 02/04/2008 - 10:55
User Badges:

Heres the error message:

Feb 04 2008 18:09:22: %ASA-5-336010: EIGRP-IPv4: PDM(334 10: Neighbor (

GigabitEthernet0/3) is up: new adjacency

The Cisco Security Appliance System Log Messages, Version 8.0

Gives me this which isn't very helpful...


Error Message %ASA-5-336010 EIGRP- tableid as_id: Neighbor address (%interface) is event_msg: msg

Explanation Neighbor Change. A neighbor went up or down.


•tableid- internal ID for the RIB

•as_id-autonomous system ID

•address-IP address of the neighbor

•interface-Name of the interface

•event_msg- Event that is occurring for the neighbor (that is, "up" or "down")

•msg-Reason for the event. Possible event_msg and msg value pairs include:

-resync: peer graceful-restart

-down: holding timer expired

-up: new adjacency

-down: Auth failure

-down: Stuck in Active

-down: Interface PEER-TERMINATION received

-down: K-value mismatch

-down: Peer Termination received

-down: stuck in INIT state

-down: peer info changed

-down: summary configured

-down: Max hopcount changed

-down: metric changed

-down: [No reason]

Recommended Action Check to see why the link on the neighbor is going down or is flapping. This may be a sign of a problem, or a problem might start occurring because of this.


This Discussion