×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

BGP Community

Answered Question
Feb 2nd, 2008
User Badges:

Router#sh route-map

route-map COMMUNITY, permit, sequence 10

Match clauses:

Set clauses:

community 13172786


where this Community comming from?as i Remembere i assigned it such 201:65



2)on the Neighbors when i issue sh ip bgp community 201:65;i didn't find any.how to toubleshoot

Correct Answer by Edison Ortiz about 9 years 6 months ago

Ali,


You need to the command ip bgp-community new-format in order to have the community displayed in the format AA:NN.




http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte_bgh1.htm#wp1074551


HTH,


__


Edison.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Danilo Dy Sat, 02/02/2008 - 09:02
User Badges:
  • Blue, 1500 points or more

Hi,


You don't have a "match clauses" and "set clauses" for route-map COMMUNITY. "community 13172786" is a community number


You should have the config...

!

route-map COMMUNITY permit 10

match ip address 101

set community 201:65

!

ip access-list 101 -entries_here-



Can you post your config?


Regards,

Dandy

alsayed@litani.... Sat, 02/02/2008 - 09:59
User Badges:

hey Dany

how you Doin?i dont need to match any ip address just i addee the rout-map to the outside neih internal route-map COMMUNITY out

but it didn't work

what now?

alsayed@litani.... Sat, 02/02/2008 - 12:55
User Badges:

yes Edisson

i solved it.i forgat to add to the Neight the command:

neigh X send-community

10xs edy

Actions

This Discussion