HW compatibility Question

Unanswered Question
Feb 2nd, 2008
User Badges:
  • Bronze, 100 points or more

Hi


Does AIM-VOICE-30 in 3725 WIC slot support? I will not use any NM or EVM, just the integrate WIC slots


2 qty VIC-2BRI-S/T-TE

and

1 qty VIC-4FXS/DID


The following links mention general support but not btwn all three


http://www.cisco.com/en/US/prod/collateral/routers/ps282/product_data_sheet09186a008009203f.html


http://www.cisco.com/en/US/products/hw/routers/ps282/products_relevant_interfaces_and_modules.html

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sat, 02/02/2008 - 10:22
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, good question. Not even the HW compatibility matrix mentions whic VIC are supported in the slots of the 37xx:

http://cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml


However, note the features available on AIM-VOICE-30 are not up to par with the latest DSP generation, so some people prefers to use a NM-HDV instead, that has PVDM2,


Hope this helps, please rate post if it does!

pcameron Sat, 02/02/2008 - 16:21
User Badges:
  • Cisco Employee,

The AIM-VOICE-30 only supports E1 or T1 interfaces that are installed in the 3725 WIC slots. It cannot be used to provide DSP resources for the FXS or BRI ports.


Refer here for more details on the capabilities of the AIM-VOICE-30 module -


http://www.cisco.com/en/US/products/hw/modules/ps3115/products_data_sheet09186a0080088753.html#wp39993


To support the combination of the BRI and FXS cards, you will need at least two voice cards such as the NM-HD-2V


http://www.cisco.com/en/US/prod/collateral/modules/ps5365/product_data_sheet0900aecd801c595e.html



Actions

This Discussion