02-02-2008 02:44 PM - edited 02-21-2020 01:53 AM
So in access lists on a pix you can specify a port number or port name. If you do specify a number which has an associated name like 80 for www, then when you do a show run you see the name and not the number. Is there any way to turn off this automatic replacement so you only see the port numbers? It would make it easier to deal with configs with scripts if I could.
02-03-2008 09:57 PM
Hi,
Nope, that's not possible
02-04-2008 11:54 AM
Sure would be nice I was just working with this too. How about adding this as a feature request similar to the "no names" command?
03-31-2009 01:47 PM
Here is a list of port and protocol values.
http://www.cisco.com/en/US/docs/security/fwsm/fwsm23/command/reference/pvalues.pdf
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: