02-03-2008 05:21 AM - edited 03-11-2019 04:58 AM
I have 2 Pix 525 .it works as Active/Standby .in my case the Active is the secondry and the standby is the primary Pix. we use Failover cable and stateful failover together .
the Sync/Failover is working fine but
When i configured subinterfaces on the inside of the Active pix(Secondry) and issued the write memory command on the Active ,the Syncronization failed and both of them become active .
When i removed the subinterfaces config and configured ACL or anything else the Failover process works fine.
Any Help Pls?
Regards,
Welcome
02-03-2008 09:37 PM
Hi,
I don't know what is the version you're running but please double-check FO configuration based on the following links:
*** For v6.x ***
http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/failover.html
*** For v7.x ***
http://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/failover.html
If everything seems to be ok, remove FO config and wipe out the configuration of standby PIX. Then configure FO back and do a "wr mem" and "wr standby" in order to copy the config from active to standby PIX.
That should work
02-04-2008 01:08 AM
thank you very much for your reply.I will try it and feedback you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide