Testing Procedure for ASA Failover

Answered Question
Feb 4th, 2008
User Badges:

Can anyone recommend the best way to run a regular failover test for a pair of ASA firewalls running in Active/Standby please?


Is it just a case of making the active unit a standby?

Correct Answer by sivakondalarao about 9 years 3 months ago

Hi,

Yes it is making active unit a standby.


1 power down the active unit to force failover to the standby unit

2 check the connectivity through standby

3 and power on the active unit.


or give (in pix os 6.3)


on primary device:

primary(config)#no failover active

check the connectivity through standby

after bring back active device by issuing below command on standby device

secondary(config)#failover active


regards

skrao



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
sivakondalarao Mon, 02/04/2008 - 03:04
User Badges:

Hi,

Yes it is making active unit a standby.


1 power down the active unit to force failover to the standby unit

2 check the connectivity through standby

3 and power on the active unit.


or give (in pix os 6.3)


on primary device:

primary(config)#no failover active

check the connectivity through standby

after bring back active device by issuing below command on standby device

secondary(config)#failover active


regards

skrao



Actions

This Discussion