02-04-2008 12:56 PM - edited 03-15-2019 08:36 AM
Hi,
I have configured a Cisco CallManager Gw MGCP with Alcatel 4300
When i make call, the call is establish, but i have no voice.
Thanks for your help.
Bye
02-04-2008 01:24 PM
You might need to add the commands
MGCP bind control source-interface
MGCP bind media source-interface
where
Apart from this, without configs from the gateway, it's hard to make other suggestions.
02-04-2008 01:25 PM
what type of gateway are you using?
If the call is up and there is no audio, then issue the following command on the gateway:
show voip rtp connection
Check the remote IP address and see if the gateway can reach that through ping.
You may need to add the mgcp bind media to your gateway's config.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: