Rob Huffman Tue, 02/05/2008 - 14:10
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Ricardo,


Q. The physical ports on the controller are currently set to operate at 1000 mbps speed. Is it possible to change this port speed to 100 mbps?


A. No, the port speed on the controller cannot be changed. These are set at 1000 mbps, full duplex speed only.



http://www.cisco.com/en/US/products/ps6366/products_qanda_item09186a008064a991.shtml



Hope this helps!

Rob

ricardorojas123 Thu, 02/07/2008 - 16:51
User Badges:

Rob, but in the CLI of the wireless lan controllers, these command are available:


(Cisco Controller) >show port summary


STP Admin Physical Physical Link Link Mcast

Pr Type Stat Mode Mode Status Status Trap Appliance POE

-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------

1 Normal Forw Enable Auto 1000 Full Up Enable Enable N/A

2 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A

3 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A

4 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A




(Cisco Controller) config>port physicalmode 1 ?

[100h/100f/10h/10f] Enter port speed and duplex setting.




???

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode