02-05-2008 09:14 AM - edited 03-03-2019 08:34 PM
Hi,
I wanted to know better way to bundle/balance multiple frame Relay t1s.
I am using IP CEF for now and here is my config:
ip cef
!
interface Serial0/0
encapsulation frame-relay
frame-relay lmi-type ansi
!
interface Serial0/0.1 multipoint
bandwidth 768
ip address 192.168.172.54 255.255.255.252
ip load-sharing per-packet
traffic-shape rate 768000 768000 768000 1000
traffic-shape fecn-adapt
frame-relay map ip 192.168.172.53 100 broadcast
!
interface Serial1/0
encapsulation frame-relay
frame-relay lmi-type ansi
!
interface Serial1/0.1 multipoint
bandwidth 768
ip address 192.168.172.58 255.255.255.252
ip load-sharing per-packet
traffic-shape rate 768000 768000 768000 1000
traffic-shape fecn-adapt
frame-relay map ip 192.168.172.57 101 broadcast
It woks fine. But I wanted to do simple qos on top of it and I am not sure about how. Anyway, here is what I would like to try:
class-map match-all TEST
match access-group 111
!
policy-map IP-POLICY
class TEST
bandwidth percent 70
class class-default
fair-queue
policy-map BANDWIDTH-POLICY
class class-default
shape average 768000
service-policy IP-POLICY
But I am not sure I can apply this on both frame interfaces.
Please help me.
Thanks!
02-05-2008 11:01 AM
You did all the hard work :)
Remove the traffic shape commands from the serial interfaces and just apply service-policy output BANDWIDTH-POLICY
You can verify the command is applied with show policy-map interface
HTH,
__
Edison.
02-05-2008 01:48 PM
Thanks! I will give it a try.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide