we have a cisco 7600 with vpn spa module, and i have to specify ip address on switch outside port for example on GigabitEthernet 4/48 (swicth outside port).
Now i want configure vpn spa module,i know i must configure port vlan (layer 2) and interface vlan (layer 3).
then connect switch outside port to vpn module by crypto-connect vlan command.
But when use this command on interface GigabitEthernet 4/48 show following message:
interface 4/48 has a ip address.
and in debug isakmp sa display following messages:
6d20h: %ACE-3-NOENGINESLOT: Interface GigabitEthernet4/48 has no crypto engine slot
6d20h: ISAKMP: Unable to get connection id for slot 0!
i have to Specify ip address on Gigabitethernet 4/48 .(network design)
Thanks your advice