02-06-2008 01:56 AM - edited 03-15-2019 08:38 AM
Hi All !
I have a problem , I am trying for the Gateways & Gatekeepers exam.
My problem is that there are 2 different answers to my question in the Cisco Press Book.
It is about controlling the bandwidth needed for calls
say a call would need 64k (ignore headers and other stuff for now)
should I configure double the bandwidth for a session ?ie
bandwidth session zone localcall 128
or leave it at 64k
then there is the interzone.....
do I also need to double the bandwidth there too per allowed call ? ie
bandwidth interzone zone localcall 256
for 2 allowed calls ?
Solved! Go to Solution.
02-17-2008 12:52 AM
Hi,
up to my knowledge you always need to double the bandwidth when configuring GK.
let's say you have one call G711=80k
in the config:
bandwidth session zone localcall 160
or
bandwidth interzone zone localcall 160
Good luck with your exam
02-12-2008 09:30 AM
Bandwidth requirement also depends on the payload size.
http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a0080094ae2.shtml
02-12-2008 10:15 PM
Yes I know that , I am just looking for clarification to what "value" the above commands should have.
02-12-2008 10:27 PM
Hi
if its G.711 then it shud be 80 Kbps per call sof ro 2 calls it shud be 160 Kbps
For G.729 it takes 24Kbps so for 2 calls it shud be 48 Kbps
Hpe this helps
02-17-2008 12:52 AM
Hi,
up to my knowledge you always need to double the bandwidth when configuring GK.
let's say you have one call G711=80k
in the config:
bandwidth session zone localcall 160
or
bandwidth interzone zone localcall 160
Good luck with your exam
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: