02-06-2008 07:56 AM - edited 03-15-2019 08:39 AM
Hello,
I use Call Manager and have a voice gateway. They are relyed by SIP trunk.
So When I call from the Call Manager to external call, there are an IVR in the called number.So i have to put many digit.
But the problem is that I cannot put the digit.
What is the problem?
The schema is :
CCM <-IP SIP Trunk -> Voice Gw <- E&M -> Router <-IP H323-> Voip Call
Thank you
02-06-2008 08:02 AM
What happens when you try to enter the first digit? Can you send me a copy of your config on the voice gateway?
02-06-2008 12:00 PM
do you have configured the DMTF relay for NTE and sip-notify on the applicable dial-peers
in order for the GW to relay the DTMFs you need to configure it on the dial-peers and also what kind of DTMF is going to be relayed
HTH
02-06-2008 08:46 PM
The trunk with the call manager 5 is a SIP.
The dtmf preference is RFC 2833.
And in the gateway router is rtp-nte, that is RFC2833 too.
Should I replace it with sip-notify?
02-06-2008 08:49 PM
Hello,
The phone is a 7971G. With a 7911G I can use the dtmf, i can enter digits when the menu ask me.
But with the 7971G, I just hear a beep in the phone when I enter the digit menu.
Many Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: