I have a Pix firewall with an UR license and it has Active/Active Failover. When I connect via console, it appears to be continuously reloading and cannot be interrupted. Only when I do esc while it's rebooting can I get the monitor> prompt. I have to enter all the monitor variables "server, addr, interface, file, Etc.." and then type TFTP and it loads the version 7 or 8 code and comes up. Problem is If I reboot it is back to square one. I have reset to factory and it still does it. Please see attached File. What is strange is that once I load the image from monitor mode, it all works well.
You are welcome Jerry.
Please do not forget to rate the post and choose "resolved my problem" which was helpful and resolved your problem.