×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Position of Device Pool for ICT remote PABX

Unanswered Question
Feb 7th, 2008
User Badges:
  • Silver, 250 points or more

I have a ICT to another cluster which I wish to set the calls to use g729 across this link


Set up


Cluster A - phones A ICT to Cluster B phones B


Calls within Cluster A use G711

Calls within Cluster B use G711


Between clusters i.e over the ICT need to use G729


Cluster A phones are assigned Device Pool A which contains Region A

Cluster B phones are assigned Device Pool B which contains Region B


Within the region A


within Region A G711

to Region B G729


Within Region B


to Region A G729

within Region B G711


What Device Pool/ Region do I assign to Cluster A ICT to force calls to use G729


I can understand that calls within the cluster the CCM know what regions setting to apply as it knows about the called phone set up - DP`S, Location etc but if the called handset is across the ICT or to another PABX via GW`s how does the CCM know what to assign - is it because you would create a new DP called ICT and create a new Region called ICT and only assign G729 so all calls use g729?



thanks








  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jason-calbert_2 Thu, 02/07/2008 - 07:30
User Badges:
  • Bronze, 100 points or more

Hello,


You are correct create a new device pool called ICT and a new region called ICT. Set the region to use G729 and in your new ICT device pool use the region ICT.


You would then assign the device pool ICT to your intercluster trunk


Hope this Helps


Jason

iptuser55 Sun, 02/10/2008 - 02:45
User Badges:
  • Silver, 250 points or more

Jason


Thanks for the confirmation

Actions

This Discussion