VPN: Having problems allowing multiple connections

eddied1963 · ‎02-07-2008

I have two road warriors that have broadband and are able to connect to the vpn with virtually no problems but when a third user who has a verizon card trys to connect it won't allow him to connect, unless i clear the crypto isakmp. Then he is able to connect but then the other users are not. I turned on debug to see what going on. can someone help!

husycisco · ‎02-07-2008

Hi Eddie,

Issue command sh ver and check if you have enough VPN peer license.

Regards

eddied1963 · ‎02-07-2008

husycisco,

This was the results of the 'sh ver'

It say's IKE peers Unlimited so I think I do

Cisco PIX Firewall Version 6.3(3)

Cisco PIX Device Manager Version 3.0(1)

Compiled on Wed 13-Aug-03 13:55 by morlee

CCX up 7 hours 18 mins

Hardware: PIX-506, 32 MB RAM, CPU Pentium 200 MHz

Flash i28F640J5 @ 0x300, 8MB

BIOS Flash AT29C257 @ 0xfffd8000, 32KB

0: ethernet0: address is 0050.54ff.b821, irq 11

1: ethernet1: address is 0050.54ff.b822, irq 10

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES-AES: Disabled

Maximum Physical Interfaces: 2

Maximum Interfaces: 2

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Limited

IKE peers: Unlimited

This PIX has a Restricted (R) license.

Serial Number: 480350848 (0x1ca19280)

Running Activation Key: 0xd0ca14d7 0xd9505ca8 0x029ca1e2 0x28f92281

Configuration last modified by enable_15 at 08:44:40.216 MST Thu Feb 7 2008

husycisco · ‎02-10-2008

Eddie,

I suggest you to upgrade your IOS to 6.3(5) first. Second, make sure you have isakmp nat-traversal 20 issued in config