LWAPP / WiSM and non-global WLANs

Unanswered Question
Feb 7th, 2008

How would I disallow LWAPP APs (managed by a WiSM) in a remote areas from supporting my guest access WLAN, without diabling the guest access WLAN globally? Right now I have the same WLANs defined on both WiSM controllers and a centralized WiSM at the core for the campus. Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
lynne.meeks Tue, 02/12/2008 - 07:13

How can one verify that a WLAN is NOT active on the APs it shouldn't be on?

I have run the WLAN override on the WCS, which is reported to be successful, yet the WLAN that should only be on TWO APs is showing up on other APs. (not to mention that that SSID is not supposed to be broadcast anywhere!)

When I look at the APs on the controller there is no indication of which WLANs are active on the AP.

How can I verify which WLANs are actually active on any particular AP?




This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode