I am doing some test on a cisco1812 with Version 12.4(11)T4 with ip sla and eem. I have configured an ip sla icmp-echo and an ip sla reaction-conf on this sla. Action-type is TrapAndTrigger (alternatively TrapOnly) threshold-type is AVERAGE.
If the rtt value goes above the upper threshold the trap is fired and the action is rearmed when it goes below the lower threshold. So this all works fine. But it I am unable to let the trap appear in the syslog of the router. 'ip sla logging traps' is configured.
The target is to have eem action doing a cli configuration when the trap is fired. I want to do this with an eem applet and 'event syslog pattern .. 'or something like this.
If this is not possible is there another way to do this?
This sounds like a job for EEM and TCL. With a TCL policy you could save the number and time of echo timeout, and only performs the configuration tasks when enough violations have occurred in a set amount of time. I don't immediately see how you would do this with an applet policy.