Etherchannel config

Unanswered Question
Feb 7th, 2008

I keep getting the following message when I bring up the 2nd trunk. It works with only the one trunk up. Does anyone know why i am getting this message. It only works with one trunk up, does not matter which one. As soon as I bring up the 2nd trunk I get the following message.


1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Thu, 02/07/2008 - 16:59

You would have to post the config , you something configured wrong . Each side must have the exact same parameters . Is this a straight etherchannel or is it trunked also ? Are you bringing up both ports at the same time . Maybe if you post we can see it.

aijaz802 Sat, 02/09/2008 - 00:52

Hi,


The two ports in an ether channel should be identical in speed/duplex settings. if its a layer 2 trunk, then the allowed vlans should be same.


Please check again and rate this if it helps...


Thanks..


*aijaz*

Actions

This Discussion