Access-point LWAPP Console Password

Answered Question
Feb 8th, 2008

I have some access-points (AIR-LAP-1231G-A-k9) working perfectly with the WLC.

However, when I put the console in the access-point it asks me to enable password default.

I would like to change this password, as I do that?

I have this problem too.
0 votes
Correct Answer by rob.huffman about 8 years 11 months ago

Hi Andre,

When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:

config ap username password

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml

Hope this helps!

Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
andre.ortega Fri, 02/08/2008 - 09:45

Hi,

thanks for help me, but when the LAP is registered to a controller this command not have.

Do know someone a command for hardware test for this LAP???

thanks

Actions

This Discussion

 

 

Trending Topics - Security & Network