02-08-2008 04:03 AM - edited 07-03-2021 03:21 PM
I have some access-points (AIR-LAP-1231G-A-k9) working perfectly with the WLC.
However, when I put the console in the access-point it asks me to enable password default.
I would like to change this password, as I do that?
Solved! Go to Solution.
02-08-2008 05:28 AM
Hi Andre,
When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:
config ap username
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
Hope this helps!
Rob
02-08-2008 05:28 AM
Hi Andre,
When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:
config ap username
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
Hope this helps!
Rob
02-08-2008 09:45 AM
Hi,
thanks for help me, but when the LAP is registered to a controller this command not have.
Do know someone a command for hardware test for this LAP???
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide