Solved: Access-point LWAPP Console Password

andre.ortega · ‎02-08-2008

I have some access-points (AIR-LAP-1231G-A-k9) working perfectly with the WLC.

However, when I put the console in the access-point it asks me to enable password default.

I would like to change this password, as I do that?

Rob Huffman · ‎02-08-2008

Hi Andre,

When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:

config ap username password

Hope this helps!

Rob

Rob Huffman · ‎02-08-2008

Hi Andre,

When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:

config ap username password

Hope this helps!

Rob

andre.ortega · ‎02-08-2008

Hi,

thanks for help me, but when the LAP is registered to a controller this command not have.

Do know someone a command for hardware test for this LAP???

thanks