Solved: Ring Setting (Phone Idle / Phone Active) System Default

flash2200 · ‎02-08-2008

Hi all,

When configuring the lines on an IP phone you can specify the "Ring Setting (Phone Idle)" and "Ring Setting (Phone Active)" parameters. One of the options you can choose is "System Default".

My question is where do you set the "System Default" for these two parameters? I can't seem to find it.

Thanks in advance for any assistance.

Rob Huffman · ‎02-08-2008

Hey Steven,

You have to dig deep for these ones :)

From ccmadmin;

Service>Service Parameters>Callmanager Service>Clusterwide Parameters (Device - Phone)

You will see the settings options here.

Hope this helps!

Rob

View solution in original post

Rob Huffman · ‎02-08-2008

Hey Steven,

You have to dig deep for these ones :)

From ccmadmin;

Service>Service Parameters>Callmanager Service>Clusterwide Parameters (Device - Phone)

You will see the settings options here.

Hope this helps!

Rob

Adam Hinchliff · ‎11-19-2014

Hi,

We run system version 9.1.2.11900-12

It is now in System>Service Parameters>Select Server>Cisco Callmanager Service>Clusterwide Parameters (Device - Phone)

Cheers

Adam