Trunking question

Unanswered Question
Feb 8th, 2008
User Badges:

Switch A is trunked to switch B and switch B is trunked to switch C (all 802.1Q).

Switch A has VLAN50 configured on it.

Switch B does not have VLAN50 configured on it.

Switch C has VLAN50 configured on it.

All switches are in VTP transparent mode.

Will VLAN50 traffic on switch A get to switch C?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Hi Peter


I don't think that traffic from VLAN50 will get from Switch A to Switch C.


With the switches in transparent mode, each switch only knows about its own VLAN's. And even though you have a VLAN50 on Switch A and a VLAN50 on Switch B, these are not the same VLAN.


What you would need to do is to have all your switches as VTP Servers or 1 switch as a VTP server and the other 2 switches as clients. In this configuration all three switches would know about VLAN50 and even if switch B had no hosts in VLAN50 attached to it, it would still pass traffic for VLAN50 from switch A over the trunk to switch B.


Best Regards,


Michael

Edison Ortiz Fri, 02/08/2008 - 10:31
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

> Will VLAN50 traffic on switch A get to switch C?


No, unless you dot1q-tunnel that Vlan, but that's another exercise :)



__


Edison.

fernandezcarlos Fri, 02/08/2008 - 12:11
User Badges:

Transparent mode will not process VTP info across trunk BUT will send all packets.


With 3 2950's, I have setup trunks with the above config and a show interfaces trunk displays vlans 1-4096 allowed on trunks of all switches.


I also setup 2 pc's on switch A and C on Vlan 50 and was able to ping from one to the other.


Cheers


Kevin Dorrell Fri, 02/08/2008 - 13:25
User Badges:
  • Green, 3000 points or more

That's very interesting.


I would be interested to see switch B show spanning-tree vlan 50. If it has a spanning-tree for that VLAN, we must ask ourselves why. If it has no spanning tree for that VLAN, then that would imply that a transparent switch could cause a loop.


Did you try show vlan on switch B, just to be 100% sure there was no VLAN 50 there?


Kevin Dorrell

Luxembourg


fernandezcarlos Fri, 02/08/2008 - 14:25
User Badges:

You are right. Vlan 50 is configured on B. I was testing concept of transparent switches sending vlan 50 without server/client mode.


I did not notice "no vlan 50 on B" in original post.


Carlos

Actions

This Discussion