02-08-2008 08:44 AM - edited 03-03-2019 08:37 PM
Hi all,
I have an issue where I will have to change the traffic shaping parameters. This will be done off hours, but I am wondering what the best practice for this is. Should I edit the current map-class or create another map-class and swap out the interface configuration. Here is the configuration I will be changing.
Change from:
map-class frame-relay shapeforT1
frame-relay cir 768000
frame-relay bc 7680
frame-relay be 0
service-policy output IPFRCOS
Change to:
map-class frame-relay shapeforT1
frame-relay cir 729600
frame-relay bc 7296
frame-relay be 0
service-policy output IPFRCOS
Thanks in advance.
02-08-2008 10:38 AM
You could edit the current map-class without any problems. I've done it plenty of times.
___
Edison.
02-08-2008 12:23 PM
I would just edit the current map, especially if traffic will be low.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: