02-08-2008 02:20 PM - last edited on 03-15-2019 08:43 AM by NikolaIvanov
Is there a command that will allow me to disconnect an active call in an IOS gateway without disrupting everyone using the PRI?
Thanks,
Josh
02-08-2008 02:24 PM
try a shut on the actual channel
voice-port 0/0/0:23.1
shut
Have not done this, I dont think, but it may work
02-08-2008 02:30 PM
No it doesn't. First the .1 notation refers to a subinterface that doesn't exists, then the only voice port that exist is 0/0/0:23, not 0/0/0:1.
02-09-2008 03:43 PM
I am not talking about the serial subinterface. I just verified on my 2811 running c2800nm-spservicesk9-mz.123-11.T10.bin that when i go to config mode and then type voice-port 0/0/0:23.1 i can enter the channel and puts me in config-voiceport mode. You actually have most of the config commands that you would for a normal voice-port. I remembered this because I had to busyout a particular channel before
02-09-2008 04:28 PM
You are right, I have tried and one can enter a notation indicating a timeslot after dot, however is taken as a synonymous for the port without the dot, so you end shutdown the D channel.
02-08-2008 02:25 PM
Try "show call active voice comapct", find ID, then clear call voice causecode 1 calling-number XXX. There is also an ID option.
Not sure if that works if you're using MGCP. If you have a badly stuck call however the above is not enough.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide