Trying to re-image a CSC-SSM module but the recover boot procedure seems to be looping.
I configure then start the "hw mod 1 recover boot"...
thmasa1f# hw m 1 recover boot
The module in slot 1 will be recovered. This may
erase all configuration and all data on that device and
attempt to download a new image for it.
Recover module in slot 1? [confirm]
Recover issued for module in slot 1
thmasa1f#
As shown below the "debug module-boot" output displays it reading the image via tftp OK.
After completing the tftp download the message "Launching TFTP Image..." is displayed.
But then it seems to go back to downloading the tftp image again.
It keeps looping like this until I issuse the "hw mod 1 recover stop" command.
I have never done this procedure before, what should happen after downloading and executing the image?
Slot-1 957> Cisco Systems ROMMON Version (1.0(11)2) #0: Thu Jan 26 10:43:08 PST 2006
Slot-1 958> Platform ASA-SSM-CSC-10
Slot-1 959> GigabitEthernet0/0
Slot-1 960> Link is UP
Slot-1 961> MAC Address: 0018.1900.3518
Slot-1 962> ROMMON Variable Settings:
Slot-1 963> ADDRESS=192.168.0.111
Slot-1 964> SERVER=192.168.0.112
Slot-1 965> GATEWAY=0.0.0.0
Slot-1 966> PORT=GigabitEthernet0/0
Slot-1 967> VLAN=untagged
Slot-1 968> IMAGE=csc6.2.1599.0.bin
Slot-1 969> CONFIG=
Slot-1 970> LINKTIMEOUT=20
Slot-1 971> PKTTIMEOUT=4
Slot-1 972> RETRY=20
Slot-1 973> tftp csc6.2.1599.0.bin@192.168.0.112
Slot-1 974> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
.
.
.
Slot-1 158> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Slot-1 159> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Slot-1 160> Received 60835523 bytes
Slot-1 161> Launching TFTP Image...
Slot-1 162> Cisco Systems ROMMON Version (1.0(11)2) #0: Thu Jan 26 10:43:08 PST 2006
Slot-1 163> Platform ASA-SSM-CSC-10
Slot-1 164> GigabitEthernet0/0
Slot-1 165> Link is UP
Slot-1 166> MAC Address: 0018.1900.3518
Slot-1 167> ROMMON Variable Settings:
Slot-1 168> ADDRESS=192.168.0.111
Slot-1 169> SERVER=192.168.0.112
Slot-1 170> GATEWAY=0.0.0.0
Slot-1 171> PORT=GigabitEthernet0/0
Slot-1 172> VLAN=untagged
Slot-1 173> IMAGE=csc6.2.1599.0.bin
Slot-1 174> CONFIG=
Slot-1 175> LINKTIMEOUT=20
Slot-1 176> PKTTIMEOUT=4
Slot-1 177> RETRY=20
Slot-1 178> tftp csc6.2.1599.0.bin@192.168.0.112
Slot-1 179> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Slot-1 180> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
.
.
.
