SRST Devices not Expected

Unanswered Question
Feb 11th, 2008
User Badges:

CCM 4.2(3)

1760 12.1(3)T

SRST 3.1


In CallManager I have 24 phones in the SRST device pool. The other device pool is set to SRST-Disable.


When I simulate a CM failure (unplug the network cable) phones that are not part of the SRST DP are being registered and phones I wish to be enabled during failover are not.


Am I missing something somewhere?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Mon, 02/11/2008 - 14:12
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Ben,


No, you aren't missing anything here. Did you check that the Phones were reset after being assigned to the specific Device Pools. Or that if the changes were done at the Device Pool Level that you chose > Update>Reset Devices after making the changes?


Hope this helps!

Rob

benharned Tue, 02/12/2008 - 13:52
User Badges:

I'm sure I have, but I will definately try to reset them again and see what happens.

Actions

This Discussion