cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
5
Replies

3725 issue

nomair_83
Level 3
Level 3

Hi all

my router keeps restarting after compressing the image and showing other common information.

I tried to boot it from ROMON but same result.

den I checked the dir flash: ,it shows me the IOS and boot flash:(IOS file)..but still keep restarting.

I think IOS is corrupted so should I use xmodem to send the IOS from pc to router or there is some other way.

5 Replies 5

Edison Ortiz
Hall of Fame
Hall of Fame

Does it show corrupted while doing a dir?

It can also be a bad PCMCIA

Check out this link for options and suggestions:

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a008009429f.shtml

HTH,

__

Edison.

Hi,

Ya when I issued dir flash: then it shows me empty.

I tried again then it shows me the IOS file.

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi, usually if decompressing succeeds, the image file is not corrupted. However to reflash or boot from tftp, send a break from terminal then type tftpdnld, it will tell how to proceed to boot from tftp.

Hope this helps, pleas erate post if it does!

I think tftpdnld is only available in 3800 series..however I'll check this comnmand

thanx

The command is available on almost all platforms since 1997.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco