cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
0
Helpful
7
Replies

nat (interface) 0 access-list 100 command erase automatically after reboot

manik.palekar
Level 1
Level 1

I have used nat0 command to transfer outside ip address directly to inside users.But whenever my pix reboots

nat (Interface) access-list 100 command erase automatically& i will have to reconfigure it every time by changing access list name .Please guide me to resolve it permentaly.

7 Replies 7

abinjola
Cisco Employee
Cisco Employee

you make this configuration via ASDM ? are those host/network being named ?

what version you running ?

hi ..

i did it by console..version 7.1 is used.i didnt get your 2nd point.

sample config...

# nat (inside) 0 access-list 100

# access-list 100 permit ip any 145.xx.xx.xx

Thanks...

looks like a bug to me..is upgrade possible for you ?

That's the price you pay for running Early

Deployment (ED) code. These are 'beta' code

as far as I am concerned.

The question is: is downgrade possible for you?

You should be running 7.0(7) because it is

General Deployment (GD) code.

CCIE Security

I would suggest for an upgrade to 7.2.3 which is quite stable and was an end to all the 7.2.x interims.

Is version 7.2(3) ED or GD?

I would STRONGLY recommed staying from any

ED code. They are just not stable.

my 2c.

hello Requester..7.0.3 doesn't support many features like U-turning of clear text traffic,PPOE,and many other...you are safe to to go 7.2.3 as this was a dead end for all interims on 7.2.x and has been quite stable...if you want to go to 7.0.7 (GD) you will loose many feature set..choice is yours.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: