cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
292
Views
0
Helpful
2
Replies

Remote accesss vpn with LDAP microsoft active directory integration

arumugasamy
Level 1
Level 1

Dear Netpros,

I need your help on the below deisgn to work with remote access vpn with LDAP for both auth and authrorization.

The ASA 5520 is located behind the internet router. The ASA act as vpn gateway. I used the ASDM to configure the

remote access vpn with LDAP authentication and authrorization. the ASA firewall inside connected to the sidewider FW outside segement and the sidewider internal goes to local LAN (192.168.1.0).

I created the pool for the remote users in the ASA with 192.168.34.0 range that is in between ASA in-sidewinder out segemt.No tunnel established but getting authenticaion failure.

Please tell me what are thesteps needed in ASA and inside LDAP server and the sidewinder firewall to configure to finish the vpn setup

Thanks

swami

2 Replies 2

irisrios
Level 6
Level 6

Make sure the security configurations such as Key timers and rekeying timers match on both the firewalls. Check if the link helps you http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800ef796.shtml. Similair steps can be carried out on ASA.

biztechcon
Level 1
Level 1

This page should help with the LDAP setup part. A word of advice is to pay close attention to the format and case of your LDAP DNs. Match it exactly with the output of the dsquery user -samid command and you'll be fine. http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808c3c45.shtml#maintask1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: