02-12-2008 07:07 AM - edited 03-15-2019 08:47 AM
We are having an h323 gateway on a 2811 router, software 12.3(8r)T7, IOS image c2800nm-ipvoice-mz.123-11.T2.bin. We are trying to implement modem passthrough on a few select dial peers.
Problem is that "modem passthrough nse codec g711ulaw redundancy" command is working only on voip dial-peers, not pots dial-peers. Is there any solution?
Solved! Go to Solution.
02-12-2008 08:01 AM
Hi Das,
Don't mention it.
There is no way of applying a codec to a pots dial-peer as you are dealing with devices from the Analog/Digital Telephony era where codecs are not used (although ISDN uses PCM which similar to G.711). You only need to specify codecs in communication between to VoIP devices i.e. Router to Router.
Regards,
Dave
02-12-2008 07:21 AM
Hi,
The purpose of Modem passthrough is to ensure that modem calls are uncompressed. This does not apply to a POTS dial-peer as you are passing the call to an Analogue or Digital trunk, E1,FXO, E&M etc...
If you are having issues with modem passthrough then let me know.
Hope this clears up any confusion, if so please rate.
Regards,
Dave
02-12-2008 07:38 AM
Hi Dave,
Thanks a ton.
IS there any way to apply codec G-711 A-law on a pots dial-peer? I guessed that it was related to modem passthrough only? Or is there something else?
Thanks & Regards,
Das.
02-12-2008 08:01 AM
Hi Das,
Don't mention it.
There is no way of applying a codec to a pots dial-peer as you are dealing with devices from the Analog/Digital Telephony era where codecs are not used (although ISDN uses PCM which similar to G.711). You only need to specify codecs in communication between to VoIP devices i.e. Router to Router.
Regards,
Dave
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide