How to access routing module on 6509 in order to enter wccp commands

Answered Question
Feb 12th, 2008
User Badges:

Hi folks, sorry for this basic question, but in the past I worked with the old cat 5000 and I used to access the routing module.


If I have a 6509 running IOS, imagine I need to execute commands on the routing module for such switch, is there any need/way to access the routing module in order to input commands. the commands I will enter:


Router-Switch(config)#ip wccp version 2

Router-Switch(config)#ip wccp 61 redirect-list MYWAAS61


Router-Switch(config)#int VLAN50

Router-Switch(config)#ip wccp 61 redirect in


(...)

Correct Answer by Jon Marshall about 9 years 3 months ago

Hi


If you are running in Native mode ie. IOS for both the supervisor and the MSFC then you just log into the 6500 and it is all IOS.


If you are running in Hybrid mode ie. CatOS on supervisor and IOS on MSFC then from switch in enable mode type


switch# sess 15


HTH


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jon Marshall Tue, 02/12/2008 - 10:47
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


If you are running in Native mode ie. IOS for both the supervisor and the MSFC then you just log into the 6500 and it is all IOS.


If you are running in Hybrid mode ie. CatOS on supervisor and IOS on MSFC then from switch in enable mode type


switch# sess 15


HTH


Jon

Actions

This Discussion