Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1507
Views
0
Helpful
4
Replies

2950 Switch ROM mode

skmdimran
Level 1
Level 1

‎02-12-2008 09:16 PM - edited ‎03-05-2019 09:07 PM

When power up switch it directly goes in the mode that shows ROM>.

ROM> ?

Commands:

r Read memory

w Write memory

d Dump memory

t Test memory

c Call address

0 Dump CP0 regs

q Quit (return)

ESC Reset system

ROM>

So i am requesting to know how will i come back my switch in normal operation.

Regards

Imran

Labels:
0 Helpful
4 Replies 4

aijaz802
Level 1
Level 1

‎02-12-2008 09:35 PM

Hi,

Enter ">reset" or "boot" to boot into normal mode.

Usually the switch goes into ROMMON mode due to various reasons like config reg setting changed,ios image corrupted/deleted. Please check n reply.

Rate if it helps..

Regards

*aijaz*

0 Helpful

skmdimran
Level 1
Level 1
In response to aijaz802

‎02-12-2008 11:18 PM

Thanks for reply. But "reset" command is not available. Only option is there " Press ESC for reset. When I press ESC it resets but comes again in ROM mode.

0 Helpful

aijaz802
Level 1
Level 1
In response to skmdimran

‎02-12-2008 11:44 PM

Hi,

Can you post the complete booting process information....it might help us..

Thanks...

0 Helpful

Goutam Sanyal
Level 4
Level 4

‎02-13-2008 01:08 AM

Hi,

Post the boot process.

Goutam

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card