02-12-2008 09:16 PM - edited 03-05-2019 09:07 PM
When power up switch it directly goes in the mode that shows ROM>.
ROM> ?
Commands:
r Read memory
w Write memory
d Dump memory
t Test memory
c Call address
0 Dump CP0 regs
q Quit (return)
ESC Reset system
ROM>
So i am requesting to know how will i come back my switch in normal operation.
Regards
Imran
02-12-2008 09:35 PM
Hi,
Enter ">reset" or "boot" to boot into normal mode.
Usually the switch goes into ROMMON mode due to various reasons like config reg setting changed,ios image corrupted/deleted. Please check n reply.
Rate if it helps..
Regards
*aijaz*
02-12-2008 11:18 PM
Thanks for reply. But "reset" command is not available. Only option is there " Press ESC for reset. When I press ESC it resets but comes again in ROM mode.
02-12-2008 11:44 PM
Hi,
Can you post the complete booting process information....it might help us..
Thanks...
02-13-2008 01:08 AM
Hi,
Post the boot process.
Goutam
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: