a problem with UT and SNMPv3

Answered Question
Feb 13th, 2008

The customer uses LMS2.6. He had used SNMPv1 for management Cisco devices by the LMS. The funcionality of LMS was OK. He changed the SNMP v1 to SNMPv3 (AuthNoPriv) and some problem with UT occured. Some end devices are not discovered using UT. The switches, where the end devices are connected, are discovered and displayed in the Topology View (the state is green). This behaviour is for different type of switches. These switches are available using SNMPv3. Do you have any idea for solving this problem? Thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion