cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
985
Views
0
Helpful
2
Replies

Unable to generate POE report in RME

jklootwijk
Level 1
Level 1

When generating the POE report in RME I get the following message:

INVREP0104: None of the selected device(s) are POE capable. Select POE supported devices to generate the report.

The devices selected are stacked WS-C3750-24PS-S switches with power enabled ports.

I did a cwcli export inventory on the database, but the elements “POEAdminStatus” , “MaximumPower” and “PowerAllocated” are also not present in the XML file.

???

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

In order for RME to think a device is POE capable, it must support the cpeExtPsePortEntPhyIndex object from the CISCO-POWER-ETHERNET-EXT-MIB. Does this switch support this object?

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

In order for RME to think a device is POE capable, it must support the cpeExtPsePortEntPhyIndex object from the CISCO-POWER-ETHERNET-EXT-MIB. Does this switch support this object?

Thank you for your reply. According to the MIB locator tool on cisco.com this MIB is first supported in version 12.2-35.SE. A slightly newer version than the one we are using.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: